It appears to have the same specs, and we expect it to perform the same. There's also a Costco variant of this monitor, known as the LC32G73TQSNXZA. Our results are only valid for the Odyssey G7 model. It's part of the 2020 Odyssey lineup, and you can see the differences between them below. We tested the 32 inch Samsung Odyssey G7, and for the most part, we expect our review to be valid for the Odyssey G7 27 inch model (C27G75T) too. If you experience this issue, let us know in the comments below. We also noticed the dimming zones flicker a bit during our Brightness tests. However, we did notice this effect with Local Dimming on, as it seems the backlight turns itself on and off a few times. We can't replicate the same flicker some people have experienced in games (see Refresh Rate) without knowing the exact game and settings used that caused this flicker-like effect. The same issue appears even after updating the firmware to version 1009.3, and the new VRR Control setting doesn't seem to change anything in regards to this flicker issue. It changes the brightness of the screen and causes horizontal lines to appear, and when we close the GIF, this effect stops and the screen returns to normal. We noticed a flicker-like effect when displaying this GIF. There have been reports of flicker with certain games, so we decided to look into it. The Samsung Odyssey G7 is flicker-free at all backlight settings, which helps reduce eye strain. Unfortunately, this solution also results in a very soft and blurry image. Adjusting the Sharpness reduces the issue, and setting it to '45' or lower eliminates it on our unit. We can reproduce the issue by displaying a specific test pattern. Update : We looked into the pixel inversion issue reported below again. It appears to vary between units, as there are multiple other confirmations of units that don't flicker, but your results could vary. The Samsung was tested in SDR, HDR, and with different games, but despite actively trying, we couldn't reproduce the issue. It did the same thing without VRR enabled, and when the image was at any other size than 100% scaling, the brightness went back up. We displayed a test photo that reportedly causes this flicker with VRR enabled, and when the image was displayed full-screen, the brightness of the screen dimmed a bit. We received reports that the backlight flickers with VRR enabled. G-SYNC only works over a DisplayPort connection. The Samsung Odyssey G7 has native FreeSync VRR support, and it's certified by NVIDIA to be G-SYNC compatible. This only happened to us after firmware update 1009.3 when Samsung added the VRR Control setting let us know if you experience the same issue. Update : Unfortunately, VRR doesn't appear to be functioning correctly with the refresh rate set to 60Hz. As all of these tests are consistent, we're confident in our measurements. With 'Black Equalizer' at 10, we measured a contrast ratio of 3922:1, at '13' it was 3935:1, and at '20' it was 3892:1, so it's not much different from our original numbers. We also tried adjusting different settings to see if that made a difference. We did it with different equipment and even with a different way to measure contrast, but we obtained very similar results. Since the contrast measurements are quite a bit higher than Samsung's specifications for this display, we remeasured the contrast ratio. Note that this contrast ratio is much higher than Samsung's advertised 2500:1 contrast, and there appears to be significant variance in contrast between units. It has a local dimming feature, but it doesn't improve the contrast ratio because the checkerboard test pattern keeps all the dimming zones on. The Samsung Odyssey G7 has a great contrast ratio, so it displays deep blacks, which is normal from a VA panel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |